Futaba 6EXH Manuel d'utilisateur télécharger pdf (Page 18)

SWSH Swashplate types selection & Swash AFR

This function can chose from two swashplate types. Swash AFR can be set, if you chose 3-S type

1-S: Independent aileron, pitch and elevator servos linked to the swashplate. Most kits are 1-S type.















3-S: With Aileron inputs, the aileron and pitch servos tilt the swashplate left and

right; with Elevator inputs, the three servos tilt the swashplate fore and aft; with Pitch

inputs, all three servos raise the swashplate up and down.

To select the swashplate types:

1. Enter the programming mode and use the MODE key to access the

“SWSH” function.

2. Use DATA INPUT lever to select swashplate type. When you want to choose

“1-S”

type, move upward with DATA INPUT lever. When you want to choose

“3-S” type, move

downward with DATA INPUT lever. When you are changing swashplate type to 1-S, or 3-S,

the 1-S, or 3-S on the display ﬂashes slow to change rapid and then stop ﬂashing to show

1-S, or 3-S solid with conformation sound.

3. Now it set the swashplate type.

To set the swash AFR:

This function only can set when you selected the 3-S swashplate type. There is no swash AFR

setting with 1-S type. This swash AFR function is to use for change the direction and amount

of servo movement on aileron, elevator, and pitch.

At ﬁrst, linkage and set the servo horn length on aileron, elevator, and pitch servos fallow by instruction manual comes with

the model. Basically “EPA” (see page12) is set near 100% with these three servos. To set the servo “reveres” function (see

page11) so that swashplate keeps horizontally and moves correct direction up and down by operating pitch control (up and

down throttle stick).

1.Enter the programming mode and use the MODE key to access the “SWSH” function.

2. Swashplate types, Conﬁrm 3-S type is selected. If 3-S type is not selected, please see

“To

select the swashplate types” and set.

3. Use select key to select the channel you wanted to set. Aileron channel

“CHA” is displayed

at ﬁrst and “%” is ﬂashing.

Move the aileron stick left and right to set the direction and amount of movement on the

aileron servo by push up or down DATA INPUT lever. Aileron movement can be adjust from

-100% to +100% .

4. Other channel (elevator and pitch) select by SELECT key to set the direction of movement

and movement amount of servo with same manner of aileron channel setting.

“CHE” is elevator and “CHP” is pitch channel on the Display.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Futaba 6EXH Manuel d'utilisateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 6EXH