Futaba SBS-01V Manuel d'utilisateur télécharger pdf (Page 2)

SBS-01V

cable

①

Measure the cable and then cut it to the desired length.

②

Cut approximately 30mm of the negative (-, black) line from the cable.

Solder the fuse inline on the negative wire and then reattach the section of wire

that was previously removed. The fuse should be attached as close to the

external power supply as possible.

③

Place a piece of heat shrink tubing over the fuse, ensuring that it covers the

soldered areas. Shrink the tubing snug to the fuse and the wire using a heat gun.

④

The cable should be connected as shown in the diagram below. The cable

gets connected to the wires that come off the ESC and connect to the battery.

⑤

The manual for the Telemetry system should be referred to after the setup is

complete; checking to make sure it functions as desired and that it provides the

correct voltage on the display.

The fuse should be attached as close to the

external power supply as possible.

Heat shrink tube

Fuse to Black line (－)

Heat shrink tube

Heat shrink

The connection is aﬃxed to the ESC on the wires

that are connected to the battery by soldering them

and then protecting them with heat shrink.

To Power Battery

To Receiver S.BUS2 port

To Motor

Fuse（mount in either direction）

Fuse

Solder welding

motor

controller

The wiring processing method of an EXT Line

FUTABA CORPORATION

1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan

Phone: +81 475 32 6982, Facsimile: +81 475 32 6983

1 2

Pas de commentaire

Futaba SBS-01V Manuel d'utilisateur Page 2