Futaba GV-1 Manuel d'utilisateur télécharger pdf (Page 30)

3232

FUNCTIONS

Speed sensor output check

Check the sensor output not only when installing the sen-

sor but periodically.

Since the magnet rotates at high speed, it is subjected to a large centrifugal

force. Check the magnet output and mounting state after about every 10 flights.

1Call the "sensor percentage"

screen with a the FUNC+ or

FUNC- key.

2Position the magnet directly below the sensor.

If 60% or more is displayed on the Sen screen, the sensor

output is OK.

3Move the magnet away from the sensor.

If 10% or less is displayed on the Sen screen, the sensor

output is OK.

If the display is less than 60% when the magnet is directly below the sen-

sor, bring the sensor closer to the magnet so that the 60% or more is dis-

played. The magnet and sensor gap criteria is approximately 1 to 2mm. If a

sensor output is not obtained even when the sensor is brought close to the

magnet, the magnet and sensor center positions may have changed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Pas de commentaire

Futaba GV-1 Manuel d'utilisateur Page 30