Futaba 2PCKA Manuel d'utilisateur télécharger pdf (Page 12)

1111

Assembly / Adjustment

Install electronic speed control heat sinks as well as other components that conduct

electricity so they can not come in contact with aluminum, carbon fiber or other mate-

rials that conduct electricity.

If for example the speed control came loose while the model was running and touched

an aluminum chassis a short circuit may occur that would cause irreparable damage to

the system as well as loss of control.

Installation Note

Noise suppression capacitors should be installed on almost all motors.

If the proper capacitors are not installed, high frequency noise will reduce range and

cause loss of control along with various other problems.

Installation Note

Inspect all linkage installations and any point where metal could come in contact with

other metal parts. Make sure these parts do not touch other metal parts under vibra-

tion.

Should a linkage or other metal parts come in contact with other metal parts under

vibration the high frequency noise generated by this contact will cause interference

and possible loss of control.

Caution

Disassembly Prohibited

Do Not disassemble any part of this system that is not specified in the instruction

manual.

Futaba will not be responsible for any damage due to improper disassembly of any

part of the radio control system.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Futaba 2PCKA Manuel d'utilisateur Page 12