Futaba 2PCKA Manuel d'utilisateur télécharger pdf (Page 9)

88

88

8

Before Operation

Battery cover

Open

AA size Batteries

(x8)

Battery Replacement

Handling Procedure For Bat-

teries (8 AA Size Batteries)

(Battery Replacement Method)

1Remove the batteries from the trans-

mitter by sliding the cover in the di-

rection of the arrow in the figure.

2Remove the used batteries.

3Load the new AA size batteries . Pay

very close attention to the polarity

markings and reinsert accordingly.

4Side the battery cover back onto the

case.

(Check)

Turn the power switch on the trans-

mitter to the ON position. Check to

see if the three LEDs light.

If the LEDs fail to light, check the

batteries for insufficient contact in the

case or incorrect battery polarity.

Caution

Always be sure you reinsert the batteries

in the correct polarity order.

If the batteries are loaded incorrectly , the

transmitter may be damaged.

When the transmitter will not be used for

any short or long period of time always

remove the batteries.

If the batteries do happen to leak , clean

the battery case and contacts thoroughly.

Make sure the contacts are free of corro-

sion.

(Battery Disposal)

Some states require special handling

when any type of battery is disposed.

Contact the State Agency responsible

for recycling hazardous waste for pro-

cedures in your area.

(Battery Alarm Display)

When the Green battery level indica-

tor (LED) goes off and the Red LED

flashes, change the batteries immedi-

ately.

BATT LEVEL

MID

FULL

LOW/CHARGE

(Behind cover)

(Green Off)

(Green Off)

(Red Flashing)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Commentaires sur ces manuels

Pas de commentaire