Futaba R303FHS Manuel d'utilisateur télécharger pdf

©FUTABA CORPORATION 2005,12

1M23N17001

R303FHS

3 Channel, HRS/PPM Auto Detection,

Synthesized Receiver

Futaba R303FHS 3 Channel HRS/PPM Auto Detection

Synthesized receiver is packed in this set.

*Speciﬁcations are subject to change without prior notice.

R303FHS RATINGS

INSTRUCTIONS

To install the Synthesized Receiver, make sure the power

switch is in the "off" position.

With the supplied plastic screwdriver, carefully turn the slots in each

dial corresponding to the channel number you wish to receive.

Change or select the channel of the transmitter to match

the channel you have selected.

Turn on the transmitter ﬁrst and then turn on the receiver.

To make sure everything is working properly it is advised

that you perform a range test with the transmitter antenna

shortest position. If you have confirmed that everything is

working properly, then please extend the transmitter antenna

completely when running your models.

•

Output/Battery Connector

"1": CH1 output

"2": CH2 output

"3": CH3 output

"B/C": Power Supply/DSC input

Frequency Dials

Antenna

• Receiving frequency:

(Refer to the package.)

• Intermediate freq.: 455kHz

• Power supply: 6.0V(Nicd 5 cells)

• Current drain: Approx. 95mA

• Size: 27.6x39.5x14.5mm

(1.09x1.56x0.57in.)

• Weight: 17g (0.60oz.)

󾙏

CAUTION

For Analog Servo Users;

󾙋

P l e a s e m a k e s u r e

that the transm i tter' s

m o d u l a t i o n i s s e t t o

"PPM".

Otherwise, the servo may result

in break-down or cause some

improper operation.

Operation with H.R.S mode;

󾙋

When use H.R.S mode

al ways u s e foll o w i ng

conditions.

Servo; 6V type Digital Servo only

Power supply; 6V Nicd battery

Transmitter setting; "HRS" mode

If the conditions are different,

control is impossible. And Fail

Safe Unit (FSU) is not available.

󾙏

WARNING

󾙋

Always use only genuine

Futaba transmitters.

Futaba will not be responsible for

problems caused by the use of

other than Futaba genuine parts.

Use the parts specified in the

instruction manual and catalog.

Operating Precautions; Once the R303FHS detect PPM mode or

HRS mode, the detected mode is locked as long as the power is

ON. When need to change the mode, please cycle power. Changing

frequency-CH also needs same operation as above.

First Digit

of channel No.

Second Digit

of channel No.

Résumé du contenu

Page 1 - Operation with H.R.S mode;

©FUTABA CORPORATION 2005,121M23N17001R303FHS012345678901234567893 Channel, HRS/PPM Auto Detection,Synthesized ReceiverFutaba R303FHS 3 Channel HR

Commentaires sur ces manuels

Pas de commentaire

Futaba R303FHS Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires de communication Futaba R303FHS. Futaba R303FHS User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba R303FHS