Futaba 12FG Manuel d'utilisateur télécharger pdf (Page 123)

123

<Data>

Curve setting operation

This section describes the setting procedure of curves which are used with the AFR function and each

mixing function.

Curve type selection

Three types of curves (EXP1, EXP2 and

POINT) can be selected.

Curve type selection

1. Use the EDIT dial to move the cursor

(reverse-video) to the [MODE] item and

push the EDIT button to switch to the

data input mode.

2. Display the curve you want to use by

turning the EDIT dial to the left or right.

*The curve type blinks.

3. When the EDIT button is pushed, the

curve type is changed. (Operate the EDIT

dial or S1 button to stop the change.)

[EXP1]: EXP1 curve

[EXP2]: EXP2 curve

[POINT]: point curve

Setting by curve type

When the curve type is selected as described above, adjustment items corresponding to the curve type

appear on the screen. Adjust each curve as described below.

(reverse-video) to the [RATE A], [RATE B],

[EXP A], or [EXP B] setting item and push

the EDIT button to switch to the data input

mode.

2. Set the rate by turning the EDIT dial to the

left or right.

Initial value: +100.0% (rate)/+0.0% (EXP

rate)

*Initial value differs depending on function.

Adjustment range: -200.0~+200.0%

(rate)/-100.0~+100.0% (EXP rate)

(When the EDIT button is pushed for 1 second, the rate is

reset to the initial value.)

Push the EDIT button to end adjustment

and return to the cursol move mode.

[Offsetting the curve horizontally in the

vertical direction]

1. Use the EDIT dial to move the cursor

(reverse-video) to the [OFFSET] setting item

and push the EDIT button to switch to the

data input mode.

2. Move the curve in the vertical direction by

turning the EDIT dial to the left or right.

Initial value: +0.0%

(When the EDIT button is pushed for 1 second, the rate is

reset to the initial value.)

Push the EDIT button to end adjustment

and return to the cursol move mode.

EXP1/EXP2 curve adjustment

(EXP1 curve)

Using the EXP1 curve is effective in smoothing

starting of the ailerons, elevator, rudder, etc.

(EXP2 curve)

Using the EXP2 curve is effective in engine

rise and other engine control.

The curve left and right rates ([RATE A],

[RATE B]) and EXP curve rate ([EXP A], [EXP

B]) can be adjusted individually. ([EXP] for

EXP2)

The curve can also be offset horizontally

([OFFSET]) in the vertical direction.

[Rate setting]

1. Use the EDIT dial to move the cursor

1 2 ... 118 119 120 121 122 123 124 125 126 127

Commentaires sur ces manuels

Pas de commentaire

Futaba 12FG Manuel d'utilisateur Page 123

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 12FG