Futaba 12FG Manuel d'utilisateur télécharger pdf (Page 125)

125

<Data>

Switch selection method

The various functions used in the T12FG can be selected by switch. The switch (including when stick,

trim lever, or VR are used as a switch) setting method is common to all functions.

Switch selection

When a switch is selected at a mixing function, etc., the selection screen shown below is called.

(Switch selection screen example)

When switch was selected

When switch was selected, ON/OFF position

setting is also performed.

*The ON/OFF setting state of each position is displayed.

1. When you want to change the ON/OFF

setting, use the EDIT dial to move the

cursor and push the EDIT button to switch

to the data input mode. Switch the ON/

Off display by turning the EDIT dial to the

left or right.

*ON/OFF display blinks.

3. When the EDIT button is pressed, the ON/

OFF setting is changed. (Operate the EDIT

dial or S1 button to stop the change.)

4. To return to the preceeding screen, move

the cursor to the [ON/OFF] at the top of

the screen and push the EDIT button.

When stick, trim lever, or knob selected

When a stick, trim lever, or knob is used as a

switch, four operation modes can be selected by

the following mode and type combination:

1. When you want to change the mode,

move the cursor to [MODE] and push the

EDIT button to switch to the data input

mode. Switch the display to the mode

you want to change by turning the EDIT

dial to the left or right and then make the

change by pushing the EDIT button.

ŏ

Mode: [LINEAR]/[SYMMETRY]

Set the ON/Off point by the method described on the next page.

Switch selection

1. Use the EDIT dial to move the cursor

(highlights) to the switch you want to

select and push the EDIT button.

*The switch blinks.

2. To return to the preceeding screen, move

the cursor to the [HARDWARE SEL.] at

the top of the screen and push the EDIT

button.

Or, move the cursor to the [ON/OFF] and

call the ON/OFF position setting screen by

pushing the EDIT button.

Alternate mode setting

ŏ

Mode: [NORMAL]/[ALTERNATE]

1. Move the cursor to the [ALTERNATE] item

and push the EDIT button to switch to the

data input mode.

2. Change to the mode you want to set by

turning the EDIT dial to the left or right.

*The mode display blinks.

3. Push the EDIT button. (Operate the EDIT dial

or S1 button to stop the change.)

4. To return to the preceeding screen, move

the cursor to the [ON/OFF] at the top of the

screen and push the EDIT button.

1 2 ... 120 121 122 123 124 125 126 127

Commentaires sur ces manuels

Pas de commentaire

Futaba 12FG Manuel d'utilisateur Page 125

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 12FG