Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur Page 10
- Page / 139
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
10
<Before Use>
BEFORE USE
Features
FASST-2.4GHz system
The T8FGS transmitter is capable of transmitting in both FASST-2.4G 7-ch and Multi-ch modes. Select
the desired modulation mode in the Frequency Menu. For complete details on how to do so, please refer to
the Frequency Selection section located elsewhere in this manual. The compatibility is dependent upon the
receiver selected. The R6208SB receiver is capable of controlling models up to 8(eight) channels by using
the outputs for conventional system and up to 14(fourteen) channels including the 2(two) digital channels
by using the output for S.BUS system. R6208SB has two (2) operation mode as shown below.
Receiver: Normal mode/High Speed mode
The "Normal mode" accepts any type of servos or the peripherals as the frame rate of the output is 14ms.
The "High Speed mode" only accepts the digital servos for outputs from 1ch to 6ch. This includes the BLS
series, and most peripheral equipment such as gyros and brushless ESCs. The frame rate of the outputs is
7ms. The outputs for other channels indicated allow the use of any type of servos as the frame rate of these
outputs are still 14ms on the High Speed mode.
FASST-2.4GHz system features:
• 2.4GHz Spread Spectrum radio communication system.
• Exclusive ID code to avoid interference from other FASST systems.
• Fail Safe (F/S) function (for throttle channel at 7-ch mode)-F/S, Battery F/S
• Dual antenna diversity (R6208SB)
• Normal mode or High Speed mode is selectable (R6208SB)
T8FGS-2.4GHz system and receiver compatibility
Transmitter
Receiver
R606FS
R6004FF, R616FFM,
R6106HF/HFC
R607FS, R617FS
R608FS, R6208SB,
R6108SB
R6014FS/HS
R6203SB,R6203SBE,R6303SB,R6303SBE(
*
)
T8FGS 2.4G System
Multi-ch mode (MLT2/MULT) — — Okay
7-ch mode Okay Okay —
Model types
Six swash types are available for helicopters. Six types of main wings and three types of tail wings are
available for airplanes and gliders. Functions and mixing functions necessary for each model type are set in
advance at the factory.
Data input
Large graphic LCD and new type Touch Sensor substantially improve ease of setup.
Stick
New stick design with improved feel, adjustable length and tension.
Ni-MH battery
T8FGS is operated by a 7.2 V/1,700 mAh Nickel-Metal Hydride battery.
SD card (Secure Digital memory card) (Not included)
Model data can be saved to an SD card (32MB-2GB). When T8FGS transmitter software files are
released, the software can be updated by using an SD card update.
(*)Since these receivers have few ports, S.BUS is used for them when using many channels.
- 8FG SUPER 1
- TABLE OF CONTENTS 2
- <Introduction> 4
- BEFORE USE 10
- Transmitter controls 13
- Receiver nomenclature 21
- Battery Charging 22
- Home screen 24
- User Menu 25
- <Basic Operation> 27
- Channel setting 27
- Easy Link (T8FGS/R6208SB) 28
- The present model 29
- Ailvator (Dual Elevator) 32
- Helicopter 34
- Fasten about 5-10cm 35
- Margin in the lead wire 35
- R6208SB Receiver 36
- MODEL BASIC SETTING PROCEDURE 37
- 12. Throttle mixing setting 42
- 13. Other special mixings 42
- System Menu functions table 43
- Mode and switch selection 45
- Operating mode selection 45
- USER NAME 48
- H/W SETTING 50
- Stick calibration method 51
- START SEL 52
- AUTO LOCK 55
- AUTO LOCK 55
- <SensorTouch™> 56
- FUNCTIONS OF LINKAGE MENU 57
- SERVO MONITOR 58
- MODEL SELECT 59
- Model deletion 60
- Model name change 60
- Model copy 60
- MODEL TYPE 61
- FREQUENCY 63
- FUNCTION 64
- SUB-TRIM 66
- FAIL SAFE 68
- END POINT 69
- IDLE DOWN 71
- SWASH RING 72
- PITCH ADJ 75
- T1-T4 SET 76
- Warning display: 77
- DATA RESET 78
- MODEL MENU (COMMON FUNCTIONS) 79
- CONDITION 80
- Condition delay setting 81
- DUAL RATE 82
- Dual rate setting procedure 83
- PROG. MIX 84
- FUEL MIX 86
- Model Menu functions list 88
- ( ) 89
- PIT CURVE 90
- THR CURVE 91
- THR DELAY 92
- AIL DIFF 93
- FLAP SET 94
- AIL to CMBFLP 95
- AIL to BRAKEFLP 96
- AIL to RUD 97
- RUD to AIL 98
- CAMBER MIX 100
- Setting method 101
- ●Activate the function 101
- ●Condition delay setting 101
- ●Rate adjustment 101
- ELE to CAMBER 102
- CMBFLP to ELE 103
- BUTTERFLY 104
- Fixed (0) Fixed (offset 105
- ●Reference point adjustment 105
- TRIM MIX 106
- AIRBRAKE 108
- ●Gyro type selection 111
- ●Sensitivity setting 111
- AILEVATOR 113
- ( ) 114
- RUD to ELE 117
- SNAP ROLL 118
- ●Master/single mode selection 119
- ●Direction switch selection 119
- MODEL MENU (HELICOPTER) 120
- PIT CURVE/PIT TRIM 121
- High Pitch/Low Pitch Trim 123
- THR CURVE/THROTTLE HOVER TRIM 124
- Throttle Hover trim 125
- Throttle limiter function 126
- THR HOLD 127
- SWASH MIX 128
- THROTTLE MIX 129
- GYRO mixing 131
- GOVERNOR mixing 133
- MODE 0％ 50％ 100％ 110％ 134
- TIMER ST1/ST2 135
- Switch Setting Method 137
- *[LOGIC] display blinks 139
- *The mode display blinks 139
Produits connexes et manuels pour Accessoires de communication Futaba 8FGAS, 8FGHS 2.4GHz
(93 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.374 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels