Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur télécharger pdf (Page 26)

Operation Mode Select (R6208SB)

The receiver operation mode is on "Normal mode" from factory shipping. To change the mode, please

adhere to the following steps:

Changing the operation mode

LED

Link/Mode Button

1. Turn off the receiver.

2. Press and hold the Link/Mode button and

turn on the receiver. Continue holding the

button for more than one(1) second. The LED

begins ashing to indicate the current status.

3. Release the button.

4. Turn off the receiver.

By doing so, the receiver will change modes.

Conrming the operation mode

Please check the operation mode by observing

the LED when turning on the receiver.

If possible ensure that there's no FASST

transmitter in operation near the receiver.

1. When the receiver is turned on:

Red when on "Normal mode"

Initially flashes green and Red (making

Orange) when in "High Speed mode". After

two(2) seconds, change to Red.

If there are additional FASST transmitters turned

on near the receiver, the LED may show the above

status for a brief moment before changing to the

status indication as shown in the "LED indication"

table below.

LED Indication (R6208SB)

Green Red Status

Off Solid No signal reception

Solid Off Receiving signals

Blink Off

Receiving signals but ID is

unmatched

0 to 1 sec. More than 1 sec.

0 sec. 1 sec.

Press and Hold time

Turn on the receiver.

No function

Showing the CURRENT

mode with blink.

Red Blink = Normal

Green/Red Blink =

High Speed

Solid as the mode changed.

Red Solid = Normal

Green/Red Solid = High

Speed

(Become Red after one (1)

second)

（Function）

To change the mode between

Normal and High Speed

（LED

Status）

(Operation Mode Select)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 138 139

Commentaires sur ces manuels

Pas de commentaire

Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur Page 26

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 8FGAS, 8FGHS 2.4GHz