Futaba 10C 2.4GHz Manuel d'utilisateur télécharger pdf (Page 91)

GOAL of EXAMPLE: STEPS: INPUTS:

Reverse servos as needed for proper

control operation. Ex: LEFT RUDDER

STICK results in leading edge of tail

rotor blades moving left. Reverse to

operate properly. P. 38.

In the

BASIC

menu, open

REVERSE

to choose

REVERSE

Choose desired servo and reverse its

direction of travel. (Ex: reverse rudder

servo.)

CH4:RUDD

REV

is highlighted.

Are you sure?

Displays.

for 1 second.

Repeat as needed.

to return to

BASIC

menu.

Adjust Travels as needed to match

model's recommended throws (usually

listed as high rates).P. 39.

In the

BASIC

menu, choose

END POINT

to choose

END POINT

Adjust the servos’ end points.

(Ex: elevator servo)

Return to

BASIC

menu.

ELEV

ELEVATOR STICK.

until up travel is as desired.

ELEVATOR STICK.

until down travel is as desired.

Repeat as needed.

Activate

THR-CUT

. P. 98. Open

THROTTLE-CUT

function.

THROTTLE-CUT

to choose

THR-CUT

Activate the function. Choose desired

switch and position to activate.

MIX

OFF

. to

POSI

. to

DOWN

With THROTTLE STICK at idle, adjust

the rate until the engine consistently

shuts off, but throttle linkage is not

binding.

Close.

C to down position.

THROTTLE STICK.

RATE

. until shuts off.

Set up throttle curve for normal.2

(Usually changes will not need to be

PDGHSULRUWR¿UVWÀLJKW3

Open the

THR-CURV/NOR

function.

Adjust if needed.

Close the function.

THR-CURV/NOR

. .

1 >

to next point.

Repeat.

Set up collective pitch curve for normal

as base of -4, center of +5,end of

+8 to +10 degrees of blade pitch for

aerobatics.

(If just learning to fly, ask

your instructor.) P. 97.

Open the

PIT-CURV/NOR

function.

Adjust each point to match desired

FXUYH([¿UVWSRLQW

Close the function.

PIT-CURV/NOR

. .

1 >

to next point.

Repeat.

Set up revo. mixing for normal. (For

heading-hold gyros, inhibit revo.) P. 97.

Open the

REVO./NOR

function.

Adjust to your desired starting point.

(Ex:

10%

Close the function.

REVO./NOR

. .

1 >

10%

to next point.

Repeat.

&RQ¿UP*\URGLUHFWLRQ1RWHLIXVLQJ

DKHDGLQJKROG$9&6J\URXVHWKH

GYRO

programming for proper setup.

See p. 106.)

With radio on, move helicopter’s tail to the right by hand.

The gyro should give right rudder input (leading edge of the tail rotor blades

move left).

If the gyro gives the opposite input, reverse direction on the gyro unit itself.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 118 119

Commentaires sur ces manuels

Pas de commentaire

Futaba 10C 2.4GHz Manuel d'utilisateur Page 91

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 10C 2.4GHz