Futaba 10C 2.4GHz Manuel d'utilisateur télécharger pdf (Page 103)

103

DELAY

: The Delay function provides a smooth transition between the trim positions whenever

OFFSET

REVO. MIXING

, or

THROTTLE HOLD

functions are turned on and off.

Adjustability:

• Separate delay times are available for aileron, elevator, rudder, throttle, and

pitch.

• With a 50% delay setting, the servo takes about a half-second to move to its

new position...quite a long time.

,QJHQHUDOGHOD\VRIDSSUR[LPDWHO\DUHVXI¿FLHQW

GOAL of EXAMPLE: STEPS: INPUTS:

Set up a delay on all channels to ease

WKH WUDQVLWLRQ IURP RQH ÀLJKW FRQGLWLRQ

to another so there are no "hard jumps."

Open the

DELAY

function.

for 1 second.

(If

BASIC

, again.)

DELAY

Adjust

AILE

response as needed. (Ex:

aileron to

+8%

Repeat for other channels.

ELEV

. Repeat step above.

Close menus and confirm slowed

transitions.

E (T10CH) or G (T10CA) from

NORMAL

IDL2

. Check that servos

move gradually to new positions.

Where next?

THR-HOLD

: see p. 99.

Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing

(

THR-CURVE, PIT-CURVE, REVO. MIX

) for idle-ups: see p. 101.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 118 119

Commentaires sur ces manuels

Pas de commentaire

Futaba 10C 2.4GHz Manuel d'utilisateur Page 103

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 10C 2.4GHz