Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur télécharger pdf (Page 94)

● Select the function name

and return to the Model

menu by touching the

RTN button.

<SensorTouch™>

FLP 2

(Camber Flap)

FLP 1

(Camber Flap)

FLP 3

(Brake Flap)

FLP 4

(Brake Flap)

FLAP SET.

[Corresponding model type]: Airplane/glider, 2 aps or more

The up/down travel of each ap (camber aps:

FLP1/2, brake flaps: FLP3/4) can be adjusted

independently for each servo according to the

wing type.

● The operation reference point of each ap can be

offset

The camber flaps of a 4-flap model can

be mixed with the brake flaps. (BRKFLP to

CMBFLP)

● An ON/OFF switch can be set.

*The display screen is an example. The actual

screen depends on the model type.

Setting method

●Flap up/down adjustment

Move the cursor to the flap (FLP) 1~4 Up or

Down item according to the wing type and

touch the RTN button to switch to the data

input mode. Adjust the travel independently

by scrolling the touch sensor.

Initial value: +100%

Adjustment range: -120~+120%

*When the RTN button is touched for one second, the rate is

reset to the initial value.)

Touch the RTN button to end the adjustment

and return to the cursor mode.

●Reference point adjustment

Move the cursor to the [OFFSET] item and

touch the RTN button to switch to the data

input mode. Adjust the operation reference

point of each flap by scrolling the touch

sensor.

Initial value: 0%

Adjustment range: -100~+100%

●Operation

reference point

offset

●Up /Down

adjustment

*When the RTN button is touched for one second, the

reference point is reset to the initial value.)

Touch the RTN button to end the adjustment

and return to the cursor mode.

●Activate the Brake FLP to Camber FLP mixing

Move the cursor to the [ACT] item and touch

the RTN button to switch to the data input

mode. Select the ACT mode by scrolling the

touch sensor.

*The display blinks.

Touch the RTN button to activate the

function and return to the cursor mode. (ON

is displayed.)

To select a switch, move the cursor to the

[SW] item and touch the RTN button to call

the selection screen. Select the switch and

set its ON direction. (Always ON at "--" setting)

*For a description of the switch selection method, see the

description at the back of this manual.

● Select [FLAP SET.] at the Model menu and

access the setup screen shown below

by touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Glider: Currently selected condition name)

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 138 139

Commentaires sur ces manuels

Pas de commentaire

Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur Page 94

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires de communication Futaba 8FGAS, 8FGHS 2.4GHz