Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur télécharger pdf (Page 20)

Installation and Removal of the HT6F1700B

Transmitter Battery

Attachment of the battery

1. Slide the battery cover on the bottom of the

transmitter toward the right side and open it.

2. Install the battery in the holder.

3. Connect the battery connector.

•Battery

•Battery Connector

4. Close the battery cover completely.

Battery Removal

Note: If you remove the battery while the

power is on, the data you have set will not

be saved.

1. Open the battery cover.

2. Disconnect the battery connector.

3. Pull up the right side of the battery and

remove the battery.

4. Close the battery cover completely.

󾛽

Warning

󾛹

Be careful not to drop the battery.

󾛻

Never disconnect the battery connector

from the T8FGS transmitter after turning

off the power until the screen is completely

blank and the transmitter has shut down

completely.

* Internal devices such as memories may be damaged.

* If there is any problem, the message "Backup Error" will

be shown the next time when you turn on the power of

the transmitter. Do not use the transmitter as it is. Send it

to the Futaba Service Center.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 138 139

Pas de commentaire

Futaba 8FGAS, 8FGHS 2.4GHz Manuel d'utilisateur Page 20